MT-550135- Panther Trim and Tilt Model 135

The MT-550135- Panther Trim and Tilt Model 135 is a Panther marine product for the application or purpose described below.

Product information

• 55-0135 - Panther Trim and Tilt Model 135
• Make your day on the water just a bit more enjoyable with out straining your muscles trying to raise and lower an outboard motor that is not equipped with trim and tilt. A simple convenience with major results. The model 135 is the perfect option for older outboard motors with bad hydraulic trim and tilts, when repair costs are prohibitively expensive.
• The heavy duty bracket is designed for outboards up to 135HP or 350 pounds and it maximizes lifting power (even greater than the outboards tilt range), and it also allows for increased tuck-under to get heavy boats on plane quickly. Adapts to clamp on or bolt-through outboards.
• With a motor rating of up to 135 HP or 350 lbs., virtually any trim and tilt need can be met by installing the Model 135 on your transom.
• A rugged 12 volt powered actuator moves the motor plate up and down, allowing the user to easily position the motor with the remote control tethered to a 12 foot cable.
• Made of 713 cast aluminum and protected with durable black powder coat, the 135 has an overall weight of 31 lbs.
• To provide adequate support for your Panther bracket, the Transom side of the bracket must be 100% covered by the boat’s transom.
• Motor Plate Dimension
• Height 11 inches [27.94 cm]
• Width 14 1/4 inches [31.2 cm]
• Height 14 inches [35.56 cm]
• Width 15 inches [38.1 cm]

Before ordering

Please compare the listed specifications and part number with your existing component. If you need help confirming compatibility, contact Jet Ski Parts Warehouse with your make, model, year and engine details.